This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

v7.400 on new hardware and new configuration

Hi,
I have finally finished building and installing V7.400 on a new low power box. The box has been  online for 12 hours, rolled through a midnight process without a problem.

It is surprising the things that now work that wouldn't work on the old ASG that had all the beta software installed.

1/. Groups in the web profiles
2/. HTTPS scanning, a couple of sites I access are using invalid certificates.


I originally configured the internal NIC to use VLANs, but some of the NICs on my LAN don't know how to handle VLANs. That caused some grief changing the configuration back to a single IP range while I investigate the VLAN problem.

A minor issue which I don't understand, some PCs are not being reported in the stats, but are in the logs. The network stats other than concurrent connections is not updating. It was before I removed the vlans and restored the internal nic to standard ethernet.
I have restarted the ASG and  not seen any updates.

Took over 12 hours to configure from scratch using paper copies of the original configuration. Still some fine tuning to be done I suspect.

So far the new ASG appears to be very responsive, the user load is very light at the moment, my PC and web broadcasts.

Ian M[:)]


This thread was automatically locked due to age.
Parents

  • I originally configured the internal NIC to use VLANs, but some of the NICs on my LAN don't know how to handle VLANs.


    Your PCs shouldn't be seeing the VLAN tags; the VLAN switch should be removing all VLAN tags except to the trunk (Astaro).

    Barry
Reply

  • I originally configured the internal NIC to use VLANs, but some of the NICs on my LAN don't know how to handle VLANs.


    Your PCs shouldn't be seeing the VLAN tags; the VLAN switch should be removing all VLAN tags except to the trunk (Astaro).

    Barry
Children
  • Hi Barry,
    thank you for that, I will have a further play. I suspect the issue arose because I was trying out some other features of the switch. The worst part to put the vlan stuff back I have to butcher the config again.

    I fixed the reporting problem, I had to do a fresh installation after screwing up the security certificates. The https scanning seems to have increased the security level as well as MS and firefox having upped theirs as well.

    One interesting point is that now the VoIP traffic is part of the normal lan group the atas all register a lot quicker and reliably.

    System is going well.

    Ian M