This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Active IP addresses

I have my astaro LAN interface connected to my external router and I have dchp scop set on the external router to connect workstation.However, on the management interface under the licensing tab, there is nothing under the active IP addresses section (Not even the one that connects to the external router.)

I can see that the traffic is going via the astaro by tracerouting. Is it ok that there is nothing under the Active IP addresses section?

This thread was automatically locked due to age.

Parents

0 Jim Tagert over 16 years ago

Wait until tomorrow then look.

If you reboot, or install firmware that requires a reboot, the license entries will not be present until after midnight.

Jim

Oh also, if you remove boxes/PCs, it takes seven days for the entries in the table to clear.
Cancel
Vote Up 0 Vote Down

Cancel
0 wingman over 16 years ago in reply to Jim Tagert

Thx Jim
I can see all the relevant information now. [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 KWD over 16 years ago in reply to wingman

I just upgraded to 7.4 from 6. I don't see anyway to reset the IP count license manager like you could in 6. How do I do that in 7.4? Or do I have to wait the 7 days for non-active IP addresses to clear...?

thx
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 KWD over 16 years ago in reply to wingman

I just upgraded to 7.4 from 6. I don't see anyway to reset the IP count license manager like you could in 6. How do I do that in 7.4? Or do I have to wait the 7 days for non-active IP addresses to clear...?

thx
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 wingman over 16 years ago in reply to KWD

I think you have to wait those 7 days...not 100% sure yet thu
Cancel
Vote Up 0 Vote Down

Cancel
0 Jim Tagert over 16 years ago in reply to KWD

I just upgraded to 7.4 from 6. I don't see anyway to reset the IP count license manager like you could in 6. How do I do that in 7.4? Or do I have to wait the 7 days for non-active IP addresses to clear...?

thx

Other than some sort of command line reset; and I do not know if one exists, you must wait the seven days for the entries to clear.

Jim
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 16 years ago in reply to Jim Tagert

There is a command line reset which has been posted to these forums, however it does not seem to actually work, at least when I tried it in 7.2 or 7.3 (the same entries come back every night).

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 16 years ago in reply to BarryG

Did anyone try setting the date ahead 7 days then just setting it back?

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel