Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 2 subscribers
  • Views 484 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro V7 security gateway - installation

EFG
Hi all,

I'm thinking about installing Astaro V7 Security gateway.
But every time i try to install Astaro the machine just restarts after i have pressed "enter" to install. It loads a few seconds and just restarts. I've tried all the installation modes.

Specs:

VIA VC860A
800MHz CPU
256MB RAM
30GB HD
3 NICS

I've also tried V6 of the security firewall, but the same. 
I read that the hardware requirements was 400Mhz, 128MB RAM min. 8GB harddisk and 2 NICS. I also tried to change the voltage, but no luck.

Any suggestions? [:S]

/EFG


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to EFG
    How many NICs do you need? Does your case have room for a PCI NIC?

    I'm not familiar with the Via Luke chipset; it's not clear what CPU that is... I believe you need to get a C7 (esther) CPU or newer if you go with VIA.

    Jetway makes lots of nice VIA mini-itx boards, but they tend to be fairly expensive.
    Stay away from the Jetway gigabit NICs as they mostly aren't supported in Astaro.

    Another option are the new Intel Atom boards, but again, not all of them work in Astaro due to the NICs.

    Check the NICs against the Astaro HCL before buying anything.
    http://www.astaro.com/lists/HCL-ASG-V7.txt

    Barry
Cookie Information Banner