Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 244 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NIC config alteration

genio
hello there i upgrade from astaro v6.314 to astaro v7.3. The upgrade has been done from a old system to a new system. i added additional 2 NICs in the new one which are better performance rather than the built-in NIC. but the problem is after the backup the built-in NIC is configured as internal network and i want to alter it to any other additional NIC which are configured as external and DMZ. So if i would make it i will be automatically log out from webadmin and it is not possible to login webadmin again. so is there any other possibility i can do that configuration and login again.


This thread was automatically locked due to age.
  • 0
    In, 'Management >> WebAdmin Settings', on the 'Access Control' tab, you can temporarily add 'Any' to the 'Allowed Networks'.  That way, you can access through the External interface if you have a problem.

    Otherwise, just change the 'Hardware:' selection in the interface definition, disconnect from the old NIC, connect to the new NIC and login again.

    Don't forget to take 'Any' out of the 'Alllowed Networks'.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Cookie Information Banner