This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installation Failed on Version 7

On a Dell Dimension 8100 P4 1.5GHz system after booting on the Astaro CD and going through the installation configuration it drops immediately into a "Installation Failed" screen with no further information.

Thoughts?

This thread was automatically locked due to age.

Parents

0 BarryG over 17 years ago

Try pressing keys ALT-F2, ALT-F3, etc., to see where it failed.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 joethall over 17 years ago in reply to BarryG

Alt-F3 mentions /install/install no such directory
Alt-F2 brings up the prompt "bash-3.1#"
Cancel
Vote Up 0 Vote Down

Cancel
0 dilandau over 17 years ago in reply to joethall

is there more than one cd/dvd drive in the computer?

Make sure there is only one drive then try to install astaro.
Cancel
Vote Up 0 Vote Down

Cancel
0 joethall over 17 years ago in reply to dilandau

I downloaded and burned 7.3 (previously it was 7.0) and it installed, apparently, just fine!
So, let's consider this thread complete.
But I'm sure I'll be back as I try to move forward.
Thanks to all that responded! [:)]
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 joethall over 17 years ago in reply to dilandau

I downloaded and burned 7.3 (previously it was 7.0) and it installed, apparently, just fine!
So, let's consider this thread complete.
But I'm sure I'll be back as I try to move forward.
Thanks to all that responded! [:)]
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data