Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 476 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

disabled eth0 interface

neillkimrey
I mistakenly disabled the internal Ethernet interface using the Webadmin page and now I can no longer access the page and no computers on my network are receiving IP addresses via DHCP. Does anyone have advice on how to re-enable the eth0 interface?


This thread was automatically locked due to age.
  • 0
    You could setup a computer with an IP on one of the other interfaces' network, and connect to webmin, assuming you allow webmin on the other networks.

    Another option would be to re-install, and restore from backup.

    There is probably also a way to do it on the command-line with 'cc', maybe you can find it by searching these forums.

    Barry
Cookie Information Banner