Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 500 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cluster Status Question

gclark
We had a hardware malfunction on one of our two ASG 320's.  As it should the slave became the master.  Once we received the replacement unit, I had connected it and everything seemed to work.  However in the High Availability console it shows the new unit with the version 7.302 with a status of UP2DATE and marked as the slave,  and the Master has an older version of 7.202 and a status as Active. 

What does the status of 'UP2DATE' mean?   I can only assume it means its a different version.

What steps do I take to make both Units with the same version?

Could I simply unplug the master so that the slave becomes the master and have the slave auto update to the 7.302 version?


Thank you in advance for your help.


This thread was automatically locked due to age.
Parents
  • 0
    Apparently, there was a bug in 7.202 that made it extremely difficult to update to 7.300 if the unit was anywhere near 100% CPU usage.

    If I were you, I'd contact Astaro Support immediately (fastest is via MyAstaro).

    I don't think your Master is updating the slave until it gets itself updated to 7.302 also, so I wouldn't just reboot the Master.

    One excellent solution is to turn off IPS and anything else you can on the Master.  According to the following link, that allows the Up2Date to complete in a normal time frame.
    https://community.sophos.com/products/unified-threat-management/astaroorg/f/52/p/26625/77499#77499

    Good luck -Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0
    Apparently, there was a bug in 7.202 that made it extremely difficult to update to 7.300 if the unit was anywhere near 100% CPU usage.

    If I were you, I'd contact Astaro Support immediately (fastest is via MyAstaro).

    I don't think your Master is updating the slave until it gets itself updated to 7.302 also, so I wouldn't just reboot the Master.

    One excellent solution is to turn off IPS and anything else you can on the Master.  According to the following link, that allows the Up2Date to complete in a normal time frame.
    https://community.sophos.com/products/unified-threat-management/astaroorg/f/52/p/26625/77499#77499

    Good luck -Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data
Cookie Information Banner