Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 295 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I can´t restart my astaro after reinstalled

Jaime Salgado
Hi,

I installed Astaro security v 7.2 in HP proliant Ml 115 (amd opteron quad core 64 bits processor), but when I restarted this, Astaro not load the system Operating. 

When I restarted , it shows the following:

root (hd0,0)
Filesystem type is ext2fs, partition is ext2fs, partition type 0x83
kernel /boot/vmlinuz root=/dev/disk/by-label/root vga=791 rootflags=data=writeback,nobh splash=silent
[linux-bzimage, setup=0x1c00, size=0x14c420]
initrd /boot/initrd

Then, It doesn´t continue and is necessary to turn off the computer.

Thanks you in advance,


Jaime


This thread was automatically locked due to age.
Parents
  • 0
    Try changing the LBA disk access mode, or the "bootable partition size", in the BIOS (or in the RAID controller bios, if you have hardware RAID).
    You may have to re-install after the change.

    Barry
Reply
  • 0
    Try changing the LBA disk access mode, or the "bootable partition size", in the BIOS (or in the RAID controller bios, if you have hardware RAID).
    You may have to re-install after the change.

    Barry
Children
No Data
Cookie Information Banner