This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

newbie need help

helloooo iam new here and i want help if it is impossible
i just install the astaro in my machine.everything ok....btw i install the astaro in alone machine outside my lan just to see it....how can i have access to the interface....need lan?

sorry for my bad english

This thread was automatically locked due to age.

0 AMros over 17 years ago

yes, need LAN - minimum between eth0 and your admin machine!
when connected go to https://192.168.0.1:4444 (or the ip address you give it while setup) and u can see...

rgds, a.
Cancel
Vote Up 0 Vote Down

Cancel
0 vasiloui over 17 years ago in reply to AMros

astaro->switch
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 17 years ago in reply to vasiloui

Exactly. [[[:)]]][[[:)]]][[[:)]]]

If you plan to do anything other than look at it you will need another ethernet card.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel
0 vasiloui over 17 years ago in reply to RFCat_vk_01

i understant.......did anyone know where is the link for download home edition.....???

thanx a lot for the replying
Cancel
Vote Up 0 Vote Down

Cancel
0 andreas over 17 years ago in reply to vasiloui

There is only one version to download. The home version is exactly the same like the gigabit enterprise edition, only the licensing makes the difference. After your 30 days evaluation is over, you can get a home user license at the my.astaro.com portal.
Cheers,
andreas
Cancel
Vote Up 0 Vote Down

Cancel
0 vasiloui over 17 years ago in reply to andreas

that good.....thanx a lot
Cancel
Vote Up 0 Vote Down

Cancel
0 vasiloui over 17 years ago in reply to vasiloui

i need help again

i just finished the istallation everything ok.......i install it on my lan finnaly......BUT i dont have internet.....i cant setup the external interface......how can i managed this?

i have modem->astaro->switch->etc

[[[:(]]][[[:(]]][[[:(]]]
Cancel
Vote Up 0 Vote Down

Cancel
0 Biffa over 17 years ago in reply to vasiloui

How is the modem connected to Astaro by Ethernet or by USB?
Cancel
Vote Up 0 Vote Down

Cancel
0 vasiloui over 17 years ago in reply to Biffa

by ethernet
Cancel
Vote Up 0 Vote Down

Cancel
0 dilandau over 17 years ago in reply to vasiloui

You will be able to configure the astaro by accessing the webadmin of the astaro from another machine connected on your LAN. In your webbrowser enter the ip address that you chose during setup, default is 192.168.2.100, along with the port of 4444
ex. https://192.168.2.100:4444

When you first access the webadmin you will setup the paswords and then a configuration wizard will run to help you with basic configuration of the device.

The network interfaces on the astaro may not be in the order you think they are so try to access the webadmin on each interface and make sure you have set the ip of the computer you are trying to access from to be in the same range as the internal interface of the astaro.
Cancel
Vote Up 0 Vote Down

Cancel