Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 2 subscribers
  • Views 654 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG120 won't reboot without PS2 connected

Markus_Hahn
I have two ASG120 which work as HA. Usually I have them working with monitor and keyboard connected. As they were on Version 6 I always had the problem that without a keyboard connected to the PS2 connector they would not reboot and hang on "::Restarting the system".
On early versions of Version 7 (at least until 7.011) they did not do that. They rebooted fine either with or without a keyboard connected.
Today I tried that under Version 7.104 and get the error again, which I was hoping went away with going to Version 7.
I get the following messages on the rebooting system:

:: restarting the system                          done   (sits there for quiete a while)

Master Resource Control: runlevel 6 has been              reached
Failed services in runlevel 6:                                     lcdforlinux pop3
Skipped services in runlevel 6:                                  ipsec-starter
INIT: no more processes left in this runlevel

There it finishes, As soon as I plug the keyboard back into the connector it continues with the boot. This is very annoying as I would like to use these units without an extra KVM.

Any help available ?


This thread was automatically locked due to age.
Parents
  • 0
    Well, since you have appliances, have you started a case with Astaro?

    That said, I have had a similar issue with software installs on certain hardware (Version 6 and Version 7)... there's a PC at one customers' site that I just leave a keyboard connected to so if we reboot their Astaro installation remotely (up2dates, etc.) it keeps going instead of hanging as you describe.  We've tried reloading it, updating the BIOS, changing all manner of BIOS settings... it's just this particular piece of hardware causes the Astaro install to behave in this manner.  With an Astaro appliance, though, you are right, it should not "hang" waiting on a keyboard to be hooked up to it.

    CTO, Convergent Information Security Solutions, LLC

    https://www.convergesecurity.com

    Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries.  Use the advice given at your own risk.

Reply
  • 0
    Well, since you have appliances, have you started a case with Astaro?

    That said, I have had a similar issue with software installs on certain hardware (Version 6 and Version 7)... there's a PC at one customers' site that I just leave a keyboard connected to so if we reboot their Astaro installation remotely (up2dates, etc.) it keeps going instead of hanging as you describe.  We've tried reloading it, updating the BIOS, changing all manner of BIOS settings... it's just this particular piece of hardware causes the Astaro install to behave in this manner.  With an Astaro appliance, though, you are right, it should not "hang" waiting on a keyboard to be hooked up to it.

    CTO, Convergent Information Security Solutions, LLC

    https://www.convergesecurity.com

    Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries.  Use the advice given at your own risk.

Children
Cookie Information Banner