This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

two rtl8169 gigabit cards. asg problems

I would like to use two rtl8169 cards however during install its very flaky
it either sometimes sees only ONE in the hardware detection or sometimes it lists them both

Then after i installed with just one being detected and i applied the updates i can no longer ping the ASG box no matter what i do.

it just wont respond.

the light on the RJ45 cable does come on at the switch side and on the card but no response to ping no matter what.

pls advise.


This thread was automatically locked due to age.
Parents
  • May sound basic, but:

    Try different cards, or maybe change just one to another type.  Common problem with cheap network cards on the same PCI bus... I normally utilize Intel NICs to get around this problem, or have a Via port and a realtek port (different makes) in the same machine.

    CTO, Convergent Information Security Solutions, LLC

    https://www.convergesecurity.com

    Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries.  Use the advice given at your own risk.

Reply
  • May sound basic, but:

    Try different cards, or maybe change just one to another type.  Common problem with cheap network cards on the same PCI bus... I normally utilize Intel NICs to get around this problem, or have a Via port and a realtek port (different makes) in the same machine.

    CTO, Convergent Information Security Solutions, LLC

    https://www.convergesecurity.com

    Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries.  Use the advice given at your own risk.

Children
No Data