This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[HCL] Astaro on Dell PowerEdge T105

Hi,

Astaro is now on a test computer, and as Dell had nice deal on low level server, I decided to purchase a T105 to install Astaro.
The problem is that the integrated NIC is not detected during Hardware test. As this server only have one PCI port (other are PCI-E ports... and i only own normal PCI NIC), Astaro only have 1 NIC available...
All i know for sure is that it's a Broadcom NIC, exact chipset seems to be 5721J up to one Dell website... But i'm not sure about that.

Is there a workaround to add the driver for this NIC?

Thanks all

Nico

This thread was automatically locked due to age.

Parents

0 drees over 18 years ago

Best bet is to use a multi-port NIC or a VLAN capable switch.

If you can post the relevant portion of `lspci -v` output from a shell that may help if Astaro sees this thread.
Cancel
Vote Up 0 Vote Down

Cancel
0 bitonw over 18 years ago in reply to drees

in my astaro i have a dell pci dual 10/100 port nic. this card has intel chip set and works fine. i bought it on ebay.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 bitonw over 18 years ago in reply to drees

in my astaro i have a dell pci dual 10/100 port nic. this card has intel chip set and works fine. i bought it on ebay.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 nda over 18 years ago in reply to bitonw

Thanks all,

I know i can buy another NIC with multiple ports, but I already have a couple of single NIC, and would like to use the integrated NIC if possible. I can't do the lspci right now, but will as soon as possible.

Regards
Cancel
Vote Up 0 Vote Down

Cancel