Hello Everyone.
I've gone through the wizard configuration for my home network. I basically have two PCs that are connected to a Gigabit switch. The ASG is also connected to the switch through the eth0 (internal) NIC. The ASG's eth1 NIC is connected directly to my cable modem.
The wizard seemed to have correctly set up my permissions, NAT, filters, etc. The only problem now is that I can't communicate to the internet. Under Network interfaces, my eth1 adapter shows that the Cable Modem's link is UP, but the state is DOWN.
I've tried resetting my modem a few times, double-checked the cable, etc. What else do I have to do to make this work? Do I have to call in to my ISP?
Thanks in advance for any advice.
This thread was automatically locked due to age.
