Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 2 subscribers
  • Views 1132 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG 220 Monitor?!

drgoebel
Hi @ all,

I am just preparing an Update from my 6.311 to v7 and I want to do that directly with the new firmware and configure it than up without importing the old config.

But now I have seen, that on the 220 there is no vga connection...

How can I change boot order to USB CD-ROM, or can configure the new installation??


This thread was automatically locked due to age.
  • 0
    Well, the boot order should have been set right at the factory --- try booting with the USB CD ROM... if it was set right, you'll see activity on the CD-ROM drive, as well as (at some point) the LCD display on the front will indicate different phases of the install.

    If, however, you are one of the unfortunate ones that have the BIOS set wrong, you have to open the case, and plug in the VGA ribbon cable (that ships with the unit, usually in the bag that has the rackmount "ears",etc.) on the system board -- it's keyed and there's only one header on the board that matches up.  Then you can set the BIOS using a USB keyboard.

    CTO, Convergent Information Security Solutions, LLC

    https://www.convergesecurity.com

    Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries.  Use the advice given at your own risk.

  • 0 in reply to BrucekConvergent
    Thanks a lot, but I can not remember where the bag is.... 

    oh, oh.....
  • 0 in reply to drgoebel
    I believe it may be a standard pinout... but I can't swear to that.  Contact your reseller, they probably have some laying around (I know I do).

    CTO, Convergent Information Security Solutions, LLC

    https://www.convergesecurity.com

    Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries.  Use the advice given at your own risk.

  • 0 in reply to BrucekConvergent
    for asg220 upgrade connect an usb-cdrom and powerup the appliance.
    For sucsessfull update you need a SAI-7.00X.iso. An ASG-7.00x.iso dont work on appliance.
    You can also monitor the boot-phase via rs232 and hyperterminal.

    regards
  • 0 in reply to gkemter
    Yep, forgot to mention, you'll need a special ISO image from your reseller to update that appliance, as the previous poster mentioned.

    CTO, Convergent Information Security Solutions, LLC

    https://www.convergesecurity.com

    Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries.  Use the advice given at your own risk.

Cookie Information Banner