This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Changing all my IP addresses

I am switching ISPs, and of course, this means total readdressing.  I have not done this for quite some time.....

I seem to recall, back in v4 that I had to rebuild EVERYTHING.  I had to start fresh with all new DNAT rules, filters, everything, as I was locked out of changing Interface addesses with until everything dependent on the addresses were removed.

So now I am on v 6.011.  I don't see myself adding an upgrade to v7 with everything else I need to do (even with it supporting OSPF and that might be of value).

So a search here did not reveal any help/experience in re-addressing.


This thread was automatically locked due to age.
Parents
  • Changing the WAN side IP addresses need not affect anything else. Changing them should be quite simple.

    Astaro ver 6.011 is a bit old, unless you meant ver 6.311, which is the current version of the 6.*** release.
Reply
  • Changing the WAN side IP addresses need not affect anything else. Changing them should be quite simple.

    Astaro ver 6.011 is a bit old, unless you meant ver 6.311, which is the current version of the 6.*** release.
Children
  • Changing the WAN side IP addresses need not affect anything else. Changing them should be quite simple.


    No all public addressed networks.  The public one and 5 internal interfaces.  The ones wiht 1918 addresses I can leave alone [:)]

    Astaro ver 6.011 is a bit old, unless you meant ver 6.311, which is the current version of the 6.*** release.


    Oops.  Got a digit wrong.  I am up2date with 6.311; just applied the update this morning.

    So it does impact a lot.  Changing the addresses of internal systems.  I even have a couple of hosts with specific rules that will be getting new addresses.