This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NIC's not detected...

I attempted to install the ASG v7 on an older Micron tower that I acquired. It has an on board NIC, and a separate NIC installed in a PCI slot. The setup did not detect and NIC's though. Am I doing something wrong, or is there a particular type of NIC that I need to get?

This thread was automatically locked due to age.

Parents

0 VelvetFog over 18 years ago

If you stick to hardware listed on the Astaro hardware compatibility list, you should be OK.

http://www.astaro.com/lists/HCL-ASG-V7.txt
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 VelvetFog over 18 years ago

If you stick to hardware listed on the Astaro hardware compatibility list, you should be OK.

http://www.astaro.com/lists/HCL-ASG-V7.txt
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 MilanoDC2 over 18 years ago in reply to VelvetFog

Thanks for all of the help, that was what I was looking for.
Cancel
Vote Up 0 Vote Down

Cancel
0 Scott_Klassen over 18 years ago in reply to MilanoDC2

I found that list by going to Astaro.com>Support>Support Resources. Good stuff there. Check out the training videos too. [:)]

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel