This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro with wireless router

OK, I'm total beginner to this, and need some assistance setting up my network.

I have my firewall box installed with Astaro SG v7, updated with the latest firmware.  I have a dual Intel ProSet NIC inside, with eth1 going to my LAN, eth0 going to my cable modem.  My cable modem goes to eth0, and is online; my LAN goes out to my wireless router (DLink DGL-4300) into it's WAN port.  The LAN IP of the firewall is 192.168.1.1, the router is 192.168.1.16.

I have Masquerading set up, LAN to WAN.  I have Packet Filtering allowing all outgoing traffic from eth1 to eth0.

But I can't get to the internet when setup like that.  I'm assuming I need something changed in the router.

Where do I start ... what do I do???? AAAAHHHHHH!?!?!

This thread was automatically locked due to age.

Parents

0 hdsr over 18 years ago

The LAN IP of the firewall is 192.168.1.1, the router is 192.168.1.16.

First:
What is "the firewall" ? The astaro LAN interface?
What is "the router" ? The Cable modem?

The post of the following list of IP's would be usefull:
Cable-modem
Astaro - WAN
Astaro - LAN
PC

And with troubleshooting:
Ping and traceroute are your friends :-)
(Make sure the astaro allows PING & TRACEROUTE.)

Robert
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 hdsr over 18 years ago

The LAN IP of the firewall is 192.168.1.1, the router is 192.168.1.16.

First:
What is "the firewall" ? The astaro LAN interface?
What is "the router" ? The Cable modem?

The post of the following list of IP's would be usefull:
Cable-modem
Astaro - WAN
Astaro - LAN
PC

And with troubleshooting:
Ping and traceroute are your friends :-)
(Make sure the astaro allows PING & TRACEROUTE.)

Robert
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data