This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VMWare ESX 2: Astaro V7003

Hello,


does anybody have the newest Version run under ESX 2 v2.5.4?

For me it totally does not work.
Main problem is, that cluster is very unstable and that the firewall
is temporarily unaccessable from inside.

This behaves very mysterious:
- Ping from my admin pc stops after approx. 20min and comes back
  after that time again very regularly.
- During timeout the ssh connection still remains intact. tcpdump
  shows no more icmp pakets coming from my pc.
- Webadmin session also stops during that period.
- This behavior is only from inside, not outside.
- ping is explicitely allowed.


HA Cluster active passive:
The dead member comes not only again after restart. If I ping the 
restarted member to its cluster adress it comes only immediately.


Could it be that astaro implemented old versions of vmware tools?


Yours

Holger


This thread was automatically locked due to age.
Parents
  • Hi

    Have been running fine here for 1 month, using ESX 2.5.3.

    I recommend that you set up HA link on a internal switch (no hardware NICs)

    Do you have any firmware up2date pending ?
Reply
  • Hi

    Have been running fine here for 1 month, using ESX 2.5.3.

    I recommend that you set up HA link on a internal switch (no hardware NICs)

    Do you have any firmware up2date pending ?
Children
  • Hello,

    since I want to vmotion between several esx host I have to use a
    physical connection.
    Support stated to me that esx 2 is to slow for heartbeat requirements.

    I am using last version of esx 2.5.4 Patch 7 and 7.004.

    Yours

    Holger
  • Hi

    I didn't mention such problem on my 2.5.3 build 32134 ...

    FYI I'm running it on a IBM x220 2x866MHz P3, RAID disks, each Astaro with 
    512MB and 2 processors

    Couldn't you use a simple cross-wired cable for the HA link ?