Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 2 subscribers
  • Views 4409 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VLANS and Cisco 2960

lkar
I am trying to setup ASG 7.002 to support VLANs. I am using the following configuration:

Cisco 2960

interface GigabitEthernet0/19
 description ASG
 switchport mode trunk
 switchport nonegotiate

ASG:
Interface eth0 is an Intel 82547GI 
Configured as VLAN interface with VLAN id 1
IP Address: 172.16.1.1/24

When I am using this configuration I loose net connectivity. All servers are on VLAN1 and ofcourse are using the same subnet. Even if I set Cisco to static VLAN 1, same thing happens. If I set eth0 on ASG as a standard interface, everything works correctly.

Any help will be appreciated.


This thread was automatically locked due to age.
Parents Reply Children
No Data
Cookie Information Banner