This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASL 6 & 7 installation problem

I just downloaded Astaro 7 (and later Astaro 6) and tried to install it.
The CD was booting just fine, I pressed ENTER to proceed with installation..
Setup was loading bzimage and initrd ... but then the computer suddenly reboots and shows the initial screen like before.
I tried all install-options like "classic" .. but everytime it ends up in the setup-options... (ENTER, classic....)

This happens with Astaro 7 and 6 .. but when I'm booting from my old Astaro 5 CD... the setup starts just fine.

I hope you can help me out.

regards

Hoiba.

This thread was automatically locked due to age.

Parents

0 KSeemann over 18 years ago

Two quick thoughts

first....
is your Hardware still supported (there were some changes to the HCL from v5 to v6...)

second...
Try burning the CD with lower speed...
Cancel
Vote Up 0 Vote Down

Cancel
0 Hoiba over 18 years ago in reply to KSeemann

well... let's say... it fits the minimum requirements [;)]
Cancel
Vote Up 0 Vote Down

Cancel
0 slada over 18 years ago in reply to Hoiba

I have the same problem with ASG 7. (I did not try 5). I burned at 4x and the same thing still happens. Any resolution to this issue?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 slada over 18 years ago in reply to Hoiba

I have the same problem with ASG 7. (I did not try 5). I burned at 4x and the same thing still happens. Any resolution to this issue?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data