This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Crash after install; limit off memory size

Hi,
we have Supermicro mb. X6DH8-XG2 with Adaptec AIC-7902 Dual Channel Ultra320 SCSI controller. After install, ASG 7.001 crash with the message attached below.
With SATA disk working fine, but the ASG system not recognized all 4 Gb memory, only 3,2.

Thanks in advance,

Miklos Madarasz

This thread was automatically locked due to age.

Parents

0 Mike_H over 18 years ago

Does the BIOS see the 4 GB?
I have 4GB but my BIOS only sees 3.2 GB
Cancel
Vote Up 0 Vote Down

Cancel
0 MaMi over 18 years ago in reply to Mike_H

Does the BIOS see the 4 GB?
I have 4GB but my BIOS only sees 3.2 GB

The BIOS recognized 4 Gb, but the ASL only 3369752k.
When run top in console mode I see only 3369752k.
Cancel
Vote Up 0 Vote Down

Cancel
0 NimmdirKeks over 18 years ago in reply to MaMi

3.5 is quite the max you can do with a 32 Bit Kernel on a 32 Bit system. This will only change with complete transfer to 64 Bit code and hardware.
With your scsi, its possible that the controller is not supported. As far I remember thy never produced any newer drivers for those.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 NimmdirKeks over 18 years ago in reply to MaMi

3.5 is quite the max you can do with a 32 Bit Kernel on a 32 Bit system. This will only change with complete transfer to 64 Bit code and hardware.
With your scsi, its possible that the controller is not supported. As far I remember thy never produced any newer drivers for those.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data