This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Web Admin Problems

Hi,

I have just installed 3 x Astaro Firewalls across 3 locations, and all seems to be working ok this far. Except I have this really strange problem. I have set all the Webadmin ports to 1100, as I was advised to change from 443, this is fine.

I can also access the local box by typing for the local ip, eg 192.168.0.1:1100. No worries there. But if I am to type the IP address of one of the other sites, for eg 150.150.150.150, i get sent to the local box. This happens from all locations. I have also tried setting the ports back to 443, and still get the same issue.

Any ideas?

This thread was automatically locked due to age.

Parents

0 NimmdirKeks over 19 years ago

Error in the NAT/MASQ config. Think another one made this error and posted it in the forum here. Just use the search.
Cancel
Vote Up 0 Vote Down

Cancel
0 beno78 over 19 years ago in reply to NimmdirKeks

Yeah, I accidently posted twice. Somebody posted the fix, I had the MASQ set to DNAT, and then a setting to Internal, instead of external.

Thanks guys!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 beno78 over 19 years ago in reply to NimmdirKeks

Yeah, I accidently posted twice. Somebody posted the fix, I had the MASQ set to DNAT, and then a setting to Internal, instead of external.

Thanks guys!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data