This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installation Help

Can someone tell me, or point me to where I would find what to do after I install the ASG software?

I'm stuck after I install it, I can't log into the web interface because I don't get an IP from it, and I don't know what to do at the command line. Please Help.

This thread was automatically locked due to age.

Parents

0 Simon Shaw over 19 years ago

You need to access the web interface.

During setup, you would have been asked which card you wanted to use for network admin on the local side, and asked for an IP address to give it.

Connect your PC to the firewall via a switch.
Set the PC's IP to same subnet as you set the firewall during install.
IE if you told the firewall to use IP 10.0.0.1 set your PC to 10.0.0.2

Once done, browse to https://10.0.0.1 (or whatever IP you set).

Bingo.
Cancel
Vote Up 0 Vote Down

Cancel
0 hi_i_am_timbo over 19 years ago in reply to Simon Shaw

Thank you. I guess I assumed DHCP was on by default. Silly me.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 hi_i_am_timbo over 19 years ago in reply to Simon Shaw

Thank you. I guess I assumed DHCP was on by default. Silly me.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data