This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Strange HA behavior

I have a setup consisting of 2 Dell PowerEdge 2800 servers in HA mode. When HA is switching back and forth, the one that is failing will shut down completely even though it is just an interface/link that is failing. Then I have to turn it on again manually.
Any ideas? I’m running vers. 6.202

Regards
Rune

This thread was automatically locked due to age.

0 NimmdirKeks over 19 years ago

Thats the normal behavior of the link control. If the link is down, the master will shut down, because of "hardware" failure. This will only occure, when a slave is present. When no slave is present, the master will stay activ even when a link is down.
Cancel
Vote Up 0 Vote Down

Cancel
0 Rune over 19 years ago in reply to NimmdirKeks

That explains it :-) Thanks!
Cancel
Vote Up 0 Vote Down

Cancel