This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

screen full with 99 999

Have just with success(I think) installed a V6.2 on a PIII machine that are at present runing a v5.xxx but after the installation is complete and I reboot
the screen becomes full with 99 99 and then the machine 'freezes'

What can I do to fix the problem?

This thread was automatically locked due to age.

Parents

0 KKnecht over 19 years ago

Maybe a hardware problem ?

Search the forum, there is a lot of information about failed HDs, motherboards, etc.
https://community.sophos.com/products/unified-threat-management/astaroorg/f/52/t/25434
https://community.sophos.com/products/unified-threat-management/astaroorg/f/52/t/25614
https://community.sophos.com/products/unified-threat-management/astaroorg/f/52/t/25482
Cancel
Vote Up 0 Vote Down

Cancel
0 carsten grønbech over 19 years ago in reply to KKnecht

yes it was a hardware problem my 'machine' lack resources!!

Thank for the help

Brgds
Carsten
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 carsten grønbech over 19 years ago in reply to KKnecht

yes it was a hardware problem my 'machine' lack resources!!

Thank for the help

Brgds
Carsten
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 RufusToofus over 19 years ago in reply to carsten grønbech

Make sure any "own Hardware" does not use the AUTO for Hard Disk detection, use the MANUAL mode so select say Type 42 LBA for the disk type.
Cancel
Vote Up 0 Vote Down

Cancel