hello everybody,
perhaps anybody can answer the following question. i have two asg 220. high availibilty is turned on, on both of them.
if i connect via webadmin i can see under "high availibility" the master and the slave in the correct status. i my opinion this ok. if make a restart over webadmin there is the slave online for a short time (a few seconds). thats ok, too.
but now, when the master has restarted i can only see the master under "high availibilty". the slave system is in the status "unknown", even after 30 minutes.
has the slave firewall not to go to the hot-standby-mode, again?
has anyone the same problem or is it correct?
thanks for answers
toette
This thread was automatically locked due to age.
