This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SkYuk2RestartRxBmu failed

Hi,
on my ASG420 with Version 6.200 used as VPN Gateway is a failure that i have never seen before and not on other ASG :

Mar 26 14:31:06 fw017 2006:03:26-14:31:06 kernel: eth4: SkYuk2RestartRxBmu failed.

Has someone else seen this and could say what it means ?

thanks
firebear

This thread was automatically locked due to age.

Parents

0 TuneUp over 19 years ago

Have you disconnect / connect your network cable?

I only get this message if I disconnect / connect my network cable on a Marvell Interface.

Is your appliance always accessible?

Regards

Christian
Cancel
Vote Up 0 Vote Down

Cancel
0 firebear_01 over 19 years ago in reply to TuneUp

Hi,
its my internetconnection on a leased line, and no its not unplugged or disconnected the message is anytime there and comes back after reboot suddenly.

thanks for your answer
firebear
Cancel
Vote Up 0 Vote Down

Cancel
0 NimmdirKeks over 19 years ago in reply to firebear_01

Normaly it shouldn't do any harm, it's a bug in the moduls for Marvell chips.
Cancel
Vote Up 0 Vote Down

Cancel
0 TuneUp over 19 years ago in reply to NimmdirKeks

After reboot your system starts the interfaces => Link up => SkYuk2RestartRxBmu failed [;)]

If you have a free Marvell Interface just try to get the link down and up again by pulling / pushing your network cable and watch the logs.

I have had a Nexcom NSA 1046 which was periodically not reachable. Is your System permanently up and reachable?

What link-speed do you have?
Cancel
Vote Up 0 Vote Down

Cancel
0 firebear_01 over 19 years ago in reply to TuneUp

Hi,

astaro service looked for it and they think its an driver-problem.

thanks
firebear
Cancel
Vote Up 0 Vote Down

Cancel
0 BrucekConvergent over 19 years ago in reply to firebear_01

Probably a driver / software problem.. Astaro has acknowledged issues in the 420/425 appliances, which use Marvell Ethernet interfaces.. wierdness like non-working link lights, errors when bridging multiple VLANs, are known, sounds like another driver problem.

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BrucekConvergent over 19 years ago in reply to firebear_01

Probably a driver / software problem.. Astaro has acknowledged issues in the 420/425 appliances, which use Marvell Ethernet interfaces.. wierdness like non-working link lights, errors when bridging multiple VLANs, are known, sounds like another driver problem.

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data