This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Set up with DSL Modem and Linksys Router

Hello all,

I am trying to configure ASG 6.1; Software installed fine however it is recognizing the wrong nic as eth0. Weird? The question is how should I connect my DSL modem? The manual indicates that the connection should be made to a hub and from the hub to the firewall. I am using a Linksys Wireless-G router with 4 LAN ports. Does anyone know how to connect this up if it is actually a viable solution?

Thanks in advance.
Skier

This thread was automatically locked due to age.

0 BarryG over 19 years ago in reply to skier

Try enabling QOS on your EXT interface...
measure your upload/download speeds, and enter them into the network-interface page.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 skier over 19 years ago in reply to BarryG

Thanks for all your support...issue I was having turned out to be user error. When I configured my DSL Modem for Bridged Ethernet (PPPoE configured on external of FW) I failed to disable the DHCP Server feature on the modem. I had already enabled the DHCP Service in ASTARO. Once I disabled the Modem's DHCP Server, traffic flowed normally.

Good Stuff
Cancel
Vote Up 0 Vote Down

Cancel