This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Intel 82573 GbE NICs not recognized in NSM 6.x

Dear colleagues,
I've downloaded trial version of Novell Security Manager (NSM) by Astaro v 6.002 from Novell site and during installation process I had only one (Intel 82562 FE chip) of three integrated NICs recognized (two others are Intel 82573 GbE chips). Subsequent update of ASL to v.6.102 had no results - I still have only one NIC for management and tty02 on COM1 as possible interfaces. Is there any possibilities to enable 82573 support in NSM/ASL (I have generic Linux drivers with 82573 support from Intel)?

This thread was automatically locked due to age.

Parents

0 BarryG over 20 years ago

http://www.astaro.org/showflat.php?Cat=&Board=UBB11&Number=63127&fpart=1&PHPSESSID=

maybe the same problem?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 FatAndy over 20 years ago in reply to BarryG

No, Barry, I've made additional experiment with installation of dual-port Intel 1000 MT server adapter (not Dell-branded, just of-the-box) into available PCI slot in this platform and it was normally recognized during installation process. But interface of this additional board is PCI-X/PCI compatible, not PCI Express as in the case with onboard 82573 chips, and this board is based on relatively old 82546xx chips. I guess it's still abscence of 82573 PCI PnP IDs in the ASG/ASL installation routine...
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 20 years ago in reply to FatAndy

OK. Astaro normally asks for the output from:
ls /proc/pci

You should probably also email it to support@astaro.com

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 20 years ago in reply to FatAndy

OK. Astaro normally asks for the output from:
ls /proc/pci

You should probably also email it to support@astaro.com

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data