This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

802.1q with astaro 6.0 in transparent mode

Hello All,

I am a freshly with astaro. I am testing astaro 6.0 in transparent mode (bridging). My network diagram is following;

Vlan 10, 20
|
|
Layer 3 switch
|
|

This thread was automatically locked due to age.

Parents

0 RFCat_vk_01 over 20 years ago

Have you setup filters and NAT so users can get through it?

Ian M [:)]
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 RFCat_vk_01 over 20 years ago

Have you setup filters and NAT so users can get through it?

Ian M [:)]
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 nitass over 20 years ago in reply to RFCat_vk_01

Thanks for reply. I did not do any NAT. My filter rule has only one rule for allow any traffic.

If I change the 802.1q links to tagged VLAN 20 and untagged VLAN 10, I can access the astaro machine. Does anyone please tell me why it is?

Thanks a lot,
Nitass
Cancel
Vote Up 0 Vote Down

Cancel