This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

eth1 not enabled

Setting up the astaro 220 for the first time. I have set all interfaces as applicable to our environment and have the eth0 & eth2 interfaces connecting without a problem. eth1 (WAN port) has no link or activity lights. I have made sure all the interface are "Enabled" in Webadmin (Green lights), but still have no link. Any ideas?

This thread was automatically locked due to age.

Parents

0 Simon Shaw over 20 years ago

What kind of WAN link is it?
Cancel
Vote Up 0 Vote Down

Cancel
0 NimmdirKeks over 20 years ago in reply to Simon Shaw

Hi,

if its a ADSL modem, you normaly must use a crossover cable.

Chris
Cancel
Vote Up 0 Vote Down

Cancel
0 dclab over 20 years ago in reply to NimmdirKeks

Thanks for the replies. It's going to a T-1 connected by a Cisco 2500 series router. As far as I know there is no crossover cable necessary for this setup. (Our current firewall does not reuqire this at least)
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 dclab over 20 years ago in reply to NimmdirKeks

Thanks for the replies. It's going to a T-1 connected by a Cisco 2500 series router. As far as I know there is no crossover cable necessary for this setup. (Our current firewall does not reuqire this at least)
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data