This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Enabling external NIC kills communications

If there is a quick howto on cable modem connections that might save some time.

I have the following setup...

cable modem
        |
router (192.168.0.1)
        |
Astaro box external (192.168.0.201)
        |
   Switch (ALSO CONNECTED TO ROUTER)
       |
Other LAN computers, including WebAdmin box internal NIC(192.168.0.200)

My problem is that if the external NIC is active, I can no longer communicate with the Astaro box.  I have tried diconnecting the switch from the router and the same thing happens.

Anyone have any ideas?

Thanks in advance....

Bill

This thread was automatically locked due to age.

Parents

0 AMros over 20 years ago

u have to use different subnet ranges on external and internal ifc - with the config u published the asl have to work in "bridge" mode - but isn't supportet!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 AMros over 20 years ago

u have to use different subnet ranges on external and internal ifc - with the config u published the asl have to work in "bridge" mode - but isn't supportet!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data