This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Does Astaro do mostly Random reads or Sequential?

I'm setting up a new Areca Raid controller and one of the parameters I can set is the stripe size for each block written to the hard drives. I can select these sizes: 4K, 8K, 16K, 32K, 64K, or 128K. If Astaro does more "random" reads then it is my understanding that I should select a smaller stripe size. If Astaro does mostly sequential reads then I should use a bigger stripe size.

Of course this may be a moot point if this Areca Raid card will not work with Astaro, but I'm keeping my fingers crossed. It comes with all the standard Linux based drivers much like 3Ware raid cards do, so we'll see! 

Anyway, I'm guessing Astaro does mostly random reads, anyone know for sure??

Thanks,
Patrick


This thread was automatically locked due to age.
Parents
  • If that's a IDE Raid, I assume it will not work with Astaro.

    Astaro does not write or read much from harddisk. Some logs, a litte bit swap, the http proxy cache, the email queue, ... Not much. So no need to use raid to have a faster system. Raid would only be useful to have a kind of redundance.

    Anyway it's random access!
    Astaro will use the harddisk constantly but it does not need to read extremly fast from it, if you have enought RAM.

    Xeno
  • An Areca controller is fantastic for a application server such as Databases, Email, etc...  but I think you're money may be better spent than to use such a beast on a firewall. 

    my two bits to support the previous comment
Reply
  • An Areca controller is fantastic for a application server such as Databases, Email, etc...  but I think you're money may be better spent than to use such a beast on a firewall. 

    my two bits to support the previous comment
Children
No Data