This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

BIG Problems migrating from V4 to V5

I'm very confuse. We migrate yesterday night our V4.021 into V5.100 and we have lots of problems in some of the imported DNAT/SNAT.

What realy drive me crazy is that SOME of them are working and SOME of them are not working. I tried to check what's going on at logs of packet filter and some others but I can find any difference between the ones working and the ones not working.

Is There some difference between the way V4 understand DNAT/SNAT and the way is understand by V5?

Did someone report a problem like this one while migrating?

I just take the decision of rollback. But I would like to know what the problem was since I'm a fan of ASTARO and right now I'm very disappointed.

Something that points into problems while migrating is that I solve some of the now working ones by deleting the DNAT/SNAT configuration and packet filter rule and re-creating them and after 15 minutes or so the rule start to work. But it's impossible to me to do that for close to 100 DNAT/SNAT rules.

Thank you in advance,
Javier

This thread was automatically locked due to age.

0 Xeno over 20 years ago

Hi.
Goto Webadmin -> Definitions -> Networks. Are there unresolved entries?
Please update to V5.101 and import the V4 backup again. There was an improvent in V5.101 regarding Network definitions. So NAT might work better in V5.101, too.

Xeno
Cancel
Vote Up 0 Vote Down

Cancel
0 Javier Fernandez over 20 years ago in reply to Xeno

I will try, but there was nothing wrong at Definitions.

The worst thing is that everything looks OK until you try to use it (the NAT rule) so there is no way to test easily.

Thank you anyway
Cancel
Vote Up 0 Vote Down

Cancel