I have run Astaro for a long time on an old Fujitsu 300 MHz, and now I wanted to test the new Astaro. So I have layed my hands on an Compaq Deskpro EN SFF with a 600 MHz cpu.
It installed fine, but I have a major problem. The network cards I put in is two 3Com 3C509B. In /etc/modules.conf there are listed
alias eth0 e100
alias eth1 3c59x
alias eth2 3c59x
But in webinterface the internal interface is listed as eth2, and there is where I have my network cable connected. But in the status there internal network is up on eth0.
What can I do to correct this? I have not tested yet, but I think I can get problems when I try to deal with the other interfaces.
This thread was automatically locked due to age.
