This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

5.006 NIC SYS ID don`t match on WebAdmin and shell

My NIC configuration:
Onboard VIA VT6102 [Rhine-II] 
DFE-580TX 4 Port

During ASL 5.005 [GA-ISO] setup i configured my "inside" NIC as eth0 and anchored it to my onboard NIC [VIA Rhine-II]...

The Hardware List in WebAdmin says:

SysID - Name/Parameters
-------------------------------------------
eth0 - D-Link DFE-580TX
eth1 - D-Link DFE-580TX
eth2 - D-Link DFE-580TX
eth3 - D-Link DFE-580TX
eth4 - VIA VT6102 [Rhine-II]

If you edit your Interface settings, the wrong hardware is also listed and after selecting the right one, Webadmin is dead.

On shell you are able to fix this...

Well, it is very difficult to configure your FireWall if you have to guess the right NIC.

For example: eth0 => eth4  [:S]

Any proposals?


This thread was automatically locked due to age.
Parents
  • ASL should pick the NIC with the lowest IRQ number to be eth0, which then becomes the default Internal interface that you initially access Webadmin on. Make sure that the NIC that you wish to use as eth0 has a lower IRQ number than the other NICs, and that its IRQ is not shared with another NIC. That should help in avoiding situations where you end up force configuring the NICs in the machine into a logical order that is different from what ASL will default to.
Reply
  • ASL should pick the NIC with the lowest IRQ number to be eth0, which then becomes the default Internal interface that you initially access Webadmin on. Make sure that the NIC that you wish to use as eth0 has a lower IRQ number than the other NICs, and that its IRQ is not shared with another NIC. That should help in avoiding situations where you end up force configuring the NICs in the machine into a logical order that is different from what ASL will default to.
Children