This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RTL 8139 (Realtek) wrong data byte ...

Hello,
I installed the ASL Evaluation 5.002 the first time, with 3 NIC's
one onboard SIS NIC, and two RTL 8139 NIC's. If I ping the RTL NIC's, 
I get sometimes the message "wrong data byte ... should be 0xa but was ...". 
The SIS NIC causes no errors. It seems that the data transfer
on the RTL NIC's is not very fast, too.

Is this a driver problem, because the RTL NIC's worked fine on
a Debian Woody Linux installation, or what could that be.
Thanks,

Blonder.


This thread was automatically locked due to age.
Parents
  • v5.002 is not available yet.  Did you mean 5.001?  Can you post the full error message.  Have you tried alternative NIC cards?  This will help in seeing if it is a driver issue.
  • Sorry, it was  Version 5.001. I tested the installation with
    one 3com card and one RTL 8139 card, the same problem,
    I think it is a motherboard problem. I can ping on the OnBoard
    SIS NIC without errors. I tested the PCI NICs with different
    IRQs and other Bios settings but I had always the same problem. Yesterday I mailed ASUS and told them the problem.
    Now I am waiting for an answer.

    Thanks for your reply,
    Blonder.
Reply
  • Sorry, it was  Version 5.001. I tested the installation with
    one 3com card and one RTL 8139 card, the same problem,
    I think it is a motherboard problem. I can ping on the OnBoard
    SIS NIC without errors. I tested the PCI NICs with different
    IRQs and other Bios settings but I had always the same problem. Yesterday I mailed ASUS and told them the problem.
    Now I am waiting for an answer.

    Thanks for your reply,
    Blonder.
Children