This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Hardware List wrong in my V5-Install?

Hi,

I have installed Astaro 5.001 on a Toshiba Magnia SG20:

1. Setup/Install on a notebook
2. Login on the notebook and aliased the network interfaces eth0 and eth1 to the Toshibas network interfaces in modules.conf
3. Removed the HD and put it in the Magnia. It worked, but...

In the hardware list it now shows the 3com hardware for the WAN interface - which really is a Intel in the Toshiba.

The LAN-Interface is shown as unknown but can be connected to. It really is a 8139too.

Everything seems to work anyway (I can connect to firewall) so how can I "refresh" the hardware list?

Thanks!

Mike Bowers

This thread was automatically locked due to age.

Parents

0 Ari Maniatis over 21 years ago

Many of the problems we have seen with network cards not being detected properly had to do with APIC and ACPI. Although these hints were for version 4, they may help you out. If they do, please add a note on the web page below the instructions to help let others know:

http://www.ish.com.au/astaro/docs/install/hardware.php
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Ari Maniatis over 21 years ago

Many of the problems we have seen with network cards not being detected properly had to do with APIC and ACPI. Although these hints were for version 4, they may help you out. If they do, please add a note on the web page below the instructions to help let others know:

http://www.ish.com.au/astaro/docs/install/hardware.php
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data