This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

V4 Install Problem on Dell PowerEdge 2400

I am installing V4 on a Dell PowerEdge 2400 with the following hardware:

Single PIII
512 MB RAM
(3) 9GB HD's in RAID 5
Dell Percraid Raid5
NEC CDROM
3Com 3c905C-TX NIC
Intel 82557/8/9/ NIC

Everything is on the HCL but it aborts the installation when I try to accept the Detected Hardware on Step3 of 8. Any ideas? Thanks.

This thread was automatically locked due to age.

0 Gene_Pinson over 22 years ago

Which version of the iso are you trying to install, there was a mention of the perc controller drivers being fixed for the install in 4.008
Cancel
Vote Up 0 Vote Down

Cancel
0 oliver.desch over 22 years ago in reply to Gene_Pinson

and RAID 1, only DELL 2650 was under testing.

read you
o|iver
Cancel
Vote Up 0 Vote Down

Cancel
0 Gene_Pinson over 22 years ago in reply to oliver.desch

Yes, but a lot of them use the same PERC controller.
Cancel
Vote Up 0 Vote Down

Cancel