Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 254 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Admin port not as selected on Install

Bob M
In a 4.0 install, the other day, I selected the second listed port (ETH1) for my admin port.  I assigned an IP address that would work on the segment I was going to connect the box to and then compleleted the install and rebooted.

I found out that ETH0 was assigned as the IP address, not ETH1.

Is this a known bug in 4.0?

 


This thread was automatically locked due to age.
  • 0
    Bob M,

    selecting the admin interface makes sense if you have different types of NICs installed.
    In fact you'd need interface cards using diiferent  drivers. Please see the hint at this point 
    of installation. Otherwise the interface first found becomes eth0. Anyway eth0 will always 
    be assigned to the selected admin interface.

    read you
    o|iver

      
Cookie Information Banner