This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro 3.2 with integrated network card

Hi to all,
I have a Pc with an integrated network card on motherboard, it is the SIS900 card.
I have the source driver for redhat 7.1 but I don't know how I can compile under astaro 3.2 because there aren't the sources and the compilators.
I found the SIS900.O compiled under astaro, but if I configure it on /etc/modules.conf it doesn't work again.
Please can you help me????
Thank you very much.
Cristiano

This thread was automatically locked due to age.

0 Marcel_01 over 22 years ago

the SIS900 from my K7S5A works fine with an ASL3.2 (and V4 of course)..

is it detected during setup? if not, please login as root and type the following:

cat /proc/bus/pci/devices | less -S

and search the second column for '10390900' - if it's present the module should work (check kernel log) - if not, post the all codes from the second column starting with 1039

/marcel
Cancel
Vote Up 0 Vote Down

Cancel
0 Lionsgarden over 22 years ago in reply to Marcel_01

Thank you for your reply...
During setup Astaro doesn't detect the card, I verified the command that you told me: cat /proc/bus/pci/drivers | less -S, I found the 10390900 but I didn't find anything on kernel log about this card.
Are there some things that I can do?
Thank you very much.
Cancel
Vote Up 0 Vote Down

Cancel
0 Marcel_01 over 22 years ago in reply to Lionsgarden

any thoughts about trying V4 ?

/marcel
Cancel
Vote Up 0 Vote Down

Cancel
0 Lionsgarden over 22 years ago in reply to Marcel_01

Maybe it can work, but our reseller told us that the version 4 is not stable in this moment but we can receive it with our maintainance in the future.
I didn't believe that we could find this problems......
I have the license for the 3.2 but I don't think that it can work with 4.0.
Any other suggestions?
Thank you very much for your time.
Cristiano
Cancel
Vote Up 0 Vote Down

Cancel