This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

1 and 0 on screen after installing 4.0

I installed the latest version, 4.0. I am having a problem after installation. After a successful installation, I reboot the server. When it starts up, the screen is filled with 1s and 0s like "10 10 10 10 10 10 10....."

I am not sure what the problem is. Any suggestions?

Thanks,
Tareef

This thread was automatically locked due to age.

Parents

0 synopex over 22 years ago

Hi Tareef,
last installatin i had the same problem. a low-level format on hd has resolve this prob. i hope it helps you too.
regards..
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 synopex over 22 years ago

Hi Tareef,
last installatin i had the same problem. a low-level format on hd has resolve this prob. i hope it helps you too.
regards..
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Marcel_01 over 22 years ago in reply to synopex

use the search function of the board, please..

this problem may be related to wrong settings in jumpering/bios/connecting your disk to the controller... also make sure there is only one disk connected...

/marcel
Cancel
Vote Up 0 Vote Down

Cancel