Hi all !
I'm testing ASL 3.2 and it's running fine with two NIC activated but when i config eth2
(Network/interface/add), I lost contact with ASL. (after save)
It happens every time i add eth2.
Tried to restart ASL but I cant reach it, have to resintall.
ASL found all tre cards in "bluescreen setup", i have tried with different 3com NICs.
I talked to a local reseller of astaro and he told me to try with 3 exactly same model of NIC.
Tested with tree new 3c905CX-TXM but problems remain.
SETUP:
Internet
|
Cable modem (Surfboard SB3100)
|
dropcable
|
eth1 (adress[:D]hcp netmask[:D]hcp gw[:D]hcp)
ASL 3.209 on P500Mhz, 128MB, 12GB
eth0 (static adress:192.168.1.200, static netmask:255.255.255.0, gw:none)
|
crossovercable
|
Win2000 (adress:192.168.1.201, netmask:255.255.255.0 gw:192.168.1.200)
And I try to add this:
eth2 (static adress:192.168.1.202, static netmask:255.255.255.0 gw:none)
eth1 get adress and netmask, I dont se the gw:ip but i can surf when paketrules are added.
Im pretty new to ASL and appreciate any comments and tips !
Thanks
This thread was automatically locked due to age.
