This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Compaq NC3134

Does ASL 3.2 work with the dual-port NIC Compaq NC3134? I can only use the first port, the other one does not change to status "up".
A single-port NIC (RLT 8029) used together with the dual-port NIC does not show any information like pci-id or irq on the web-interface.

This thread was automatically locked due to age.

Parents

0 Suppentrulli over 23 years ago

Thanks!
Cancel
Vote Up 0 Vote Down

Cancel
0 Simon Shaw over 23 years ago in reply to Suppentrulli

Check the HCL in the documentation area and see if your NIC is listed.
Cancel
Vote Up 0 Vote Down

Cancel
0 Suppentrulli over 23 years ago in reply to Simon Shaw

I've already done this.

ASL detects an Intel 8255x NIC (there are two i82559 chipsets on the NC3134 NIC) and for this reason ASL should work with it.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Suppentrulli over 23 years ago in reply to Simon Shaw

I've already done this.

ASL detects an Intel 8255x NIC (there are two i82559 chipsets on the NC3134 NIC) and for this reason ASL should work with it.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Suppentrulli over 23 years ago in reply to Suppentrulli

I've tested my server with two dual-port NC3134 NICs. Everything workes fine, so I guess there was a problem with my Realtek 8029.
Cancel
Vote Up 0 Vote Down

Cancel