Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 2 subscribers
  • Views 647 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Version 3.02 does not allow me to change IP address during install

Tester100
I think this is directed at Astaro, I've installed 3.202 and always have to accecpt the default admin address of 192.168.2.100, is this going to fixed or is this bug.

Thanks.


This thread was automatically locked due to age.
Parents
  • 0
    no, it works ok.

    the only thing is that u have to specify ip, a valid netmask and a valid gw for that ip, i.e.

    10.1.2.1
    255.255.0.0
    10.1.2.100

    the gw cannot be the astaro itself...

    ok, this *may* be a bug, since on the admin
    interface normally we don't need a gw

    but just specify a valid ip, then, after installation, u can delete the gw on the admin nic  
    and set it to "none".
  • 0 in reply to emgadmin
    You could set the gateway to "none" during install too   [;)]  

    CU,
    RT
     
     [size="1"][ 16 July 2002, 05:09: Message edited by: redtoad ][/size]
  • 0 in reply to redtoad
    Originally posted by redtoad:
    You could set the gateway to "none" during install too    [;)]   

    CU,
    RT
    I also found that the gateway has to relate (be in the same IP range) as the IP address entered.

    So if the IP is 192.168.1.100 the gateway has to be in the 192.168.1.* range as well.
Reply
  • 0 in reply to redtoad
    Originally posted by redtoad:
    You could set the gateway to "none" during install too    [;)]   

    CU,
    RT
    I also found that the gateway has to relate (be in the same IP range) as the IP address entered.

    So if the IP is 192.168.1.100 the gateway has to be in the 192.168.1.* range as well.
Children
No Data