This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Install Problems

I downloaded the ISO for Astaro 3.2, and burnt it. When I tried to install, I could not boot from the CD. I even tried on different CDROMS and computers...No luck!

The CD itself is fine.

Any suggestions?

This thread was automatically locked due to age.

0 micio over 23 years ago

Did you allow from BIOS setting to boot from
Cd-rom drive?
Cancel
Vote Up 0 Vote Down

Cancel
0 xeon22 over 23 years ago in reply to micio

Yes, it will boot with any other CD eg. RedHat, Windows, etc.

Looking at the filesystem on the Astaro CD, doesn't look like it is bootable.
Cancel
Vote Up 0 Vote Down

Cancel
0 micio over 23 years ago in reply to xeon22

Did you burn the Cd as Astaro says on docs.astaro.org in burn How-to?
Cancel
Vote Up 0 Vote Down

Cancel
0 tichy over 23 years ago in reply to micio

I have same problem. I can't boot and install Astaro 3.2 on my computer. I try everything. (Various CDRoms, new BIOS etc.)
Astaro 2.0 I can install on this computer without problems.
I have only pentium I, maybe it is cause of this problem.

[size="1"][ 28 June 2002, 09:22: Message edited by: tichy ][/size]
Cancel
Vote Up 0 Vote Down

Cancel
0 emgadmin over 23 years ago in reply to tichy

Have you tried the boot from another computer?
Just to see if the cd boot ok...
Cancel
Vote Up 0 Vote Down

Cancel
0 tichy over 23 years ago in reply to emgadmin

Yes, I tried boot CD from another computer (with same CD-ROM), it worked ok.
Cancel
Vote Up 0 Vote Down

Cancel
0 ljdummyh over 23 years ago in reply to tichy

ive got the same problem when installing. boot from the cd fails with an error message saying that the boot failed. couldnt find cdrom device.
any suggestions? maybe the hardware to old?
Cancel
Vote Up 0 Vote Down

Cancel
0 micio over 23 years ago in reply to ljdummyh

Is rewritable Cd or normal?
Because some old Cd-rom reader don't support
RW cd.
ciao
Cancel
Vote Up 0 Vote Down

Cancel
0 ljdummyh over 23 years ago in reply to micio

Its a standard cdr from JVC, 80min 700mb
Cancel
Vote Up 0 Vote Down

Cancel
0 micio over 23 years ago in reply to ljdummyh

try to format(low-level) plus f-disk your hard-disk and than install ASL.
hope this resolve your problem.
P.S.:could you post your hardware configuration
(microprocessor etc.etc...).
ciao
Cancel
Vote Up 0 Vote Down

Cancel