Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 2 subscribers
  • Views 1202 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

New install setup

biapar
After installing ASL 3.2 i don't connect to 192.168.2.100 for setup because my ip number is different.
Is there a tool (no via http) for initial setup of ASL (ex: setup)..
thanks..  [:S]


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to biapar
    You can change the local/admin IP address during setup, BUT the first ISO release of 3.2 had a bug that would not allow zero values, so that

        192.168.101.1 

    works, but

        192.168.0.1

    will not be accepted. An updated 3.2 release was made within 48 hours (IIRC), so you might try re-downloading and re-burning the ISO.

    All the passwords are defined when you first connect to the ASL box via httpS
  • 0 in reply to ReD-MaN
    Setup wizard don't permit to change initial IP also it don't permit to setup password for admin and loginuser....
      [:S]
  • 0 in reply to YuppieScum
    Yes, into 2.x version I could to change IP, but into setup of 3.2v no.
  • 0 in reply to biapar
    Originally posted by biapar:
    Yes, into 2.x version I could to change IP, but into setup of 3.2v no.
    You can change it but you have to change the gateway to match. So if you change from 192.168.1.100 to say, 172.16.1.100 you need to change teh gateway as well to the 172.16.* range.