Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 2 subscribers
  • Views 804 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Please, i need help...

chrizzo
I dont know why, but after the execution of mdw, i always get the message 'no ip-adress on eht0'. then after a while, i get an ip, and he writes it correctly on the screen. Is this correct, or can i do something against it ?
thx

[ 02 June 2002: Message edited by: chrizzo ]



This thread was automatically locked due to age.
  • 0
    Hello chrizzo,

    that is ok. 
    The IP of the eth0 interface is written to tty0, and while eth0 is not configured (e.g. after a restart)
    "No ip-address on eth0" is printed.

    Daniel Stutz
  • 0 in reply to anonymous_02
    quote:
    Originally posted by dstutz:

    and while eth0 is not configured (e.g. after a restart)
    "No ip-address on eth0" is printed.

    Daniel Stutz


    Hello Daniel,
    there is the phenomenon, after the first reboot the message "No ip-address on eth0" stays and no beeps show readyness.
    When I reboot asl again, all is fine.
    Any hints?

    BTW: The pppoe-problem disappeared, after replacing the harddisk
  • 0 in reply to jader_01
    Hello jader,

     
    quote:
    no beeps show readyness


    means, that there "are" no beeps?

    Can you send "/var/log/mdwlog" to dstutz@astaro.com?

    Thank you.

    Daniel Stutz