This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ISA SCSI Controller 3.2

Hi
It is possible to use an AHA 1540 Adaptec or similar ISA SCSI Controller in the ASL V3.2 ??

Greetings

Roger [:)]

[ 29 May 2002: Message edited by: rogerhafner ]

This thread was automatically locked due to age.

Parents

0 vipwolf over 23 years ago

ISA Cards are not supported
Cancel
Vote Up 0 Vote Down

Cancel
0 SeaWolf over 23 years ago in reply to vipwolf

Even though ISA isn't officially supported, it may work. It won't cost you anything to simply download the ISO and give it a try, it may work and even if it doesn't you haven't lost anything by trying.
Cancel
Vote Up 0 Vote Down

Cancel
0 rogerhafner over 23 years ago in reply to SeaWolf

Thanks
i will Try it
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 rogerhafner over 23 years ago in reply to SeaWolf

Thanks
i will Try it
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Orjan Sandland over 23 years ago in reply to rogerhafner

SeaWolf, what do you base your suggestions on?

If Astaro does not compile ISA support into the kernel, ISA will not work :-). I do know for sure that an ISA NIC is NOT recognized whatsoever. I have tried.

Roger, of course you may try to make your ISA SCSI card, but do yourself a huge favour and get a cheapo PCI SCSI card. An AHA-2940 or similar comes really cheap these days.

[ 31 May 2002: Message edited by: Orjan Sandland ]
Cancel
Vote Up 0 Vote Down

Cancel
0 rogerhafner over 23 years ago in reply to Orjan Sandland

@ Ørjan
Danks for your replay
My board has only 3 PCI Slots and 2 ISA Slot and i have to use 3 PCI NIC cards. but i have also an IDE Controller so i can take a IDE Disk.

Greetings
Roger

[ 31 May 2002: Message edited by: rogerhafner ]

[ 31 May 2002: Message edited by: rogerhafner ]
Cancel
Vote Up 0 Vote Down

Cancel