This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem at Bootup with NIC Tulip and Realtek

[:(]
After complete installation, I rebooted the system (of course I removed all CD's etc. from their drives). ASL started to load the drivers for my DLINK DFE 530TX NIC (Tulip chipset) and returned an "invalid operand: 0000" following that it put out a stack ID and a Call Trace. All at the end it said "ETH0:unknown interface: no such device" (ASL detected all cards at start of installation up front without problems).

After the "ETH0:...." It tried to load my Realtek 8139 NIC but all that came out was: "8139too Fast Ethernet Driver 0.9.18"

After that the system stuck. No bash or some else.

Thanks for any help.

X.3.R.0.U.L.

This thread was automatically locked due to age.

0 Dennis Koslowski over 23 years ago

Hello,

which ASL version did you test?

Greetings,
--
Dennis
Cancel
Vote Up 0 Vote Down

Cancel
0 X3R0UL over 23 years ago in reply to Dennis Koslowski

I installed version 2.0 from the original cd I received at the network world security days by mr herbst.

greetings
Cancel
Vote Up 0 Vote Down

Cancel
0 Dennis Koslowski over 23 years ago in reply to X3R0UL

Could you please send me the output of the command:

cat /proc/bus/pci/devices | awk '{print $2}'

Thank you,
--
Dennis
Cancel
Vote Up 0 Vote Down

Cancel
0 X3R0UL over 23 years ago in reply to Dennis Koslowski

Hmmm, impossible since the machine hangs up after the last error message. I don't even know how to abort the error message and get to the shell. Any other advise how I could get the info to you ?

best regards
Cancel
Vote Up 0 Vote Down

Cancel
0 X3R0UL over 23 years ago in reply to X3R0UL

Oh wait how about I shoot the screen with the web cam and send you the file via email [;)]

best regards
Cancel
Vote Up 0 Vote Down

Cancel
0 Dennis Koslowski over 23 years ago in reply to X3R0UL

You could start the installation and answer "bash please" instead of "yes" in the first dialog; after that you should have a shell... [:)]

Thank you,
--
Dennis
Cancel
Vote Up 0 Vote Down

Cancel
0 X3R0UL over 23 years ago in reply to Dennis Koslowski

Hi,

at what email adress shall I send it ?
Cancel
Vote Up 0 Vote Down

Cancel
0 Dennis Koslowski over 23 years ago in reply to X3R0UL

Just click on the icon with an envelope in any of my postings... [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 X3R0UL over 23 years ago in reply to Dennis Koslowski

Hmmm, can't add an attachment there. Any other idea ?
Cancel
Vote Up 0 Vote Down

Cancel